Quality, safety & lifecycle services
With you before the order, and long after start-up.
With you before the order, and long after start-up
A plant is only as good as the decisions made before it is built and the care it gets after. HiTorq supports owners across the full project lifecycle, from the first feed sample to years of operation.
Feed analysis, route selection, budgetary cost
Process and detailed engineering
Group workshops, inspection
Erection, piping, electricals
Start-up and trial runs
Operators, lab and maintenance
Spares, service, upgrades
- Quality plans and inspection checklists for each project
- Material traceability for pressure parts
- Pressure and leak testing before dispatch
- Third-party inspection on request
- Closed systems and vapour recovery where solvents are handled
- Pressure and vacuum relief protection
- Flameproof electricals for hazardous areas
- Interlocks and alarms in the control system
- Effluent treatment integrated into the flow sheet
- Minimum solid waste from finishing routes
- Documentation support for statutory and environmental approvals
- Designs adapted to local norms
Classroom and on-site training for operators, shift engineers, lab chemists and maintenance staff during commissioning, with operating manuals and standard operating procedures.
Spare parts, consumables such as catalyst and filter media, periodic health checks, troubleshooting and capacity or quality upgrades as your market grows.
- Feed type, source and any lab analysis you have
- Products you want and the specifications they must meet
- Target capacity and operating hours
- Site location, available utilities and space
- Existing equipment that could be reused
Fabrication standards
Columns, pressure vessels, reactors, heat exchangers and storage tanks are fabricated by our group company Shree Shakti Engg Works at its two manufacturing units in Gujarat, including U-stamp pressure vessels.
- All grades of stainless steel
- Carbon steel and high-alloy steels
- Copper and aluminium
- Titanium, Hastelloy and Monel internals
- ASME pressure vessel design
- TEMA for heat exchangers
- Internal inspection protocol
- Third-party inspection by reputed agencies, as specified